Discussions

• Assigning General Properties to a 1D Beam Element in CXX

  75 views 1 comment 0 points Most recent by Victor August 25
• RBE3 distributing coupling between Shell and Beam in Calculix

  94 views 2 comments 0 points Most recent by Aftab August 14
• Unable see the Results for Material Part defined as CCX card

  91 views 1 comment 0 points Most recent by Victor February 22
• Convergence Issue with Concrete (Linear Compression) and Steel Interface

  231 views 9 comments 0 points Most recent by Aftab February 27
• Concrete as Non-Linear Material in Mecway

  113 views 2 comments 0 points Most recent by Aftab February 10
• Contact with Shells

  346 views 10 comments 0 points Most recent by Aftab December 2025
• Tubular to Tubular Quad Mapped Meshing

  182 views 7 comments 0 points Most recent by Aftab October 2025
• Cracks in Mesh : Only shows up in Results Calculix

  158 views 2 comments 0 points Most recent by Aftab May 2025
• Contact: Test Model

  234 views 6 comments 0 points Most recent by Aftab March 2025
• Unable to Run Plastic Analysis this simple model

  211 views 5 comments 0 points Most recent by Aftab June 2024
• create a script to generate a circular surface area around the hole

  333 views 3 comments 0 points Most recent by cwharpe June 2024
• Shell Contact Issues -simple model

  224 views 3 comments 0 points Most recent by Aftab October 2023
• * Error in Add_sm_st: coefficient should be zero

  181 views 2 comments 0 points Most recent by Aftab September 2023
• Contact issues

  245 views 4 comments 0 points Most recent by Aftab January 2023
• Improving performance of CCX solver

  259 views 8 comments 0 points Most recent by Aftab November 2022
• How to add Node Displacements to the table results

  86 views 2 comments 0 points Most recent by Aftab May 2021
• LBA: Different Results with Internal VS CCX Solver

  215 views 8 comments 0 points Most recent by Aftab April 2021
• Use of IA-FEMESH in Mecway

  198 views 2 comments 0 points Most recent by Aftab March 2021
• CCX Error "Too Many Cut backs, best solution and residuals are in the frd file"

  899 views 8 comments 0 points Most recent by Aftab February 2021
• Modeling Compression Only Support in Buckling and Non Linear

  313 views 5 comments 0 points Most recent by rwhirley February 2021